Fanuc Robodrill T14Ia Series FANUC ROBODRILL
This amazing machine tool is available in short, standard and long bed models. This manual describes installation, maintenance and.FANLJC ROBODRILL qIEseries FANUC ROBODRILL a-iE series is a high speed versatile Al CNC drill with spindle taper size No. 30 for high precision and high efficiency production. High speed, high precision, and ultimate efficiency Nano CNC System.H.s a I tra precis on p se coderfor conlrolwlth loterpo ation and feedback r nafometersFANUC CNC & Servo motor technology. Wide range of application.This manual describes installation, maintenance and operation methods for Fanuc Robodrill D21MiA machines.
...
At least then it know that there is a tool out there, and when you command it to go to Z 1.00" it will not try to shove the 4" tool 3" into the part.But the control forces you to turn it off at every occasion, and will even cancel it on occasion just out of meanness.I don't know if the model A is like that or not.Also, I found out that every other control I've ever worked with it can handle an M08 and an M03 on the same line. Also, it will cancel it at some points, and tell you it did not.I always felt that leaving the tool length comp turned ON was a good thing. You cannot leave the tool length compensation turned on, or it will hang up at some point. It can mess itself in MDI mode if you don't.Also, If you home the Z axis it WILL cancel the G43 (length offset) and LIE about it.The screen will tell you that it still has a G43 set, even though it does NOT.IOW, it forces you to do everything possible to attempt a crash. Also, you need to cancel via a G80, G40 G49 at the end of every program.
You need a separate line for the M08 and the M03.
0 kommentar(er)
